development of roller ends forced-contact model and cambering technology for ucm temper mill (ii)——development of cambering technology for ucm temper mill发展辊两端forced-contact ucm平整机模型和辊型设计技术(ii)u2014u2014ucm平整机辊型设计技术的发展.pdfVIP

Engineering, 2011, 3, 743-749 doi:10.4236/eng.2011.37089 Published Online July 2011 (http://www.SciRP.org/journal/eng) Development of Roller Ends Forced-Contact Model and Cambering Technology for UCM Temper Mill (II) ——Development of Cambering Technology for UCM Temper Mill Zhenhua Bai1 1 1 1 1 2 , Xiaodong Shi , Hongxin Si , Linfang Han , Ruibing Long , Shoumin Wu , Xiujun Li2, Dongdong Zhang1 1School of Mechanical Engineering, State Key Laboratory of Metastable Materials Science and Technology, Yanshan University, Qinhuang Island, China 2 Thin Strip Co., Ltd ., Baoshan Iron Steel Co ., Ltd ., Shanghai, China E-mail : bai_zhenhua@, sihongxin@ 126.com, xiaodong_shi@ 126.com Received April 18, 2011; revised May 18, 2011; accepted May 25, 2011 Abstract Roller ends forced-contact and overmuch roll consumption are the widespread problems in temper rolling process of thin strip for two-stand UCM temper mill. Fully thinking the equipment and technology charac- teristics of UCM temper mill, we took the newly-built 1220 UCM temper mill of Baosteel as the research object in this paper. A model of roller ends forced-contact and a calculation model of flatness for UCM tem- per mill are established after a great deal of site tracing and theoretical researches. On this basis, an optimal mathematical model of roll shape which is suited for UCM temper mill is developed. Working roll curve is the combination of cosine curve and high order curve. The cosine subentry is used to control edge wave, the high order curve subentry is used to control roller ends forced-contact. Furthermore, the chamfering curve of middle roller end is