dynamic crack propagation problems of fibre-reinforced concrete纤维增强混凝土的动态裂纹扩展问题.pdfVIP

Hindawi Publishing Corporation Advances in Civil Engineering Volume 2012, Article ID 971472, 10 pages doi:10.1155/2012/971472 Research Article Dynamic Crack Propagation Problems of Fibre-Reinforced Concrete Y. H. Cheng,1 Lu Nian Chun,2 and Li Xin-gang3 1 School of Resources Civil Engineering, Northeastern University, Shenyang 110004, China 2 School of Materials, Shenyang Ligong University, Shenyang 110168, China 3 School of Civil Engineering, Harbin Engineering University, Harbin 150001, China Correspondence should be addressed to Y. H. Cheng, neu cyh@163.com Received 28 June 2011; Accepted 17 October 2011 Academic Editor: Muhammad Hadi Copyright © 2012 Y. H. Cheng et al. This is an open access article distributed under the Creative Commons Attribution License, which permits unrestricted use, distribution, and reproduction in any medium, provided the original work is properly cited. Applying the built dynamic crack model of fibre concrete, bridging fiber segment is substituted by loads. When a crack propagates its fiber continues to break. By the approaches of the theory of complex functions, the problems dealt with can be translated into Riemann-Hilbert problems. Analytical solutions of the displacements, stresses, and dynamic stress intensity factors under the 2 2 3 2 action of of moving variable loads Px /t and Pt /x , respectively, are attained by the ways of self-similar measures. After those analytical solutions are utilized by superposition theorem, the solutions of arbitrary complex problems can be obtained. 1. Introduction concentration abates; therefore the strength and toughness of