用AVR单片机Atmega16产生两路互补PWM波去控制全桥逆变电路程序.docVIP

用AVR单片机Atmega16产生两路互补PWM波去控制全桥逆变电路程序 #include avr/io.h void main(void) { PORTB=0x00; DDRB=0x0E; // T/C1 初始化 TCCR1A=0xA1; TCCR1B=0x09; //匹配时清零，TOP:255,频率：8M/256=31.25K OCR1A=85; //占空比：1/3 OCR1B=128; //占空比：1/2 // T/C2 初始化 TCCR2=0x69; //匹配时清零，TOP:255,频率：31.25K OCR2=170; //占空比：2/3 while (1); } 使用M16产生三路PWM的程序，参考一下基本OK 还有个是可调节的PWM程序，我做过仿真了，需要全部留下邮箱传给你; /***************************************************** #define KEY PINC.0 #define PWMA PORTB.3 //17号脚 #define PWMB PORTB.4 //18号脚 #include mega8.h #include delay.h #include math.h unsigned int m=0; unsigned char xiangxian=0; bit INIT2=0; //判断是否象限2已经初始化； bit INIT3=0; bit INIT4=0; /*下面为四个象限中处理函数，参数为45度平分为255段角度*/ inline panduan() { if(m=255) { xiangxian=1; } else if((m255)(m511)) { xiangxian=2; if(m==256) { INIT2=1; PWMA=0; OCR1A=0x00; OCR1B=0xff; PWMB=1; } } else if((m=511)(m767)) { xiangxian=3; } else if((m=767)(m1024)) { xiangxian=4; } else if(m1024) { m=0; } } void xiangxian1(unsigned char degree) { PWMA=0; PWMB=0; OCR1BL=m; OCR1AL=255-m; } void xiangxian2(unsigned char degree) { unsigned char temp; temp=m-255; OCR1AL=temp; OCR1BL=temp; } void xiangxian3(unsigned char degree) { unsigned char temp; temp=m-511; PWMA=1; PWMB=1; OCR1BL=255-temp; OCR1AL=temp; } void xiangxian4(unsigned char degree) {unsigned char temp=0; temp=m-767; PWMA=1; PWMB=0; OCR1BL=255-temp; OCR1AL=255-temp; } /*角度计算函数，负责计算在各个象限中角度对应的PWM输出*/ void SET_ANGLE( unsigned char degree) { switch (xiangxian) { case 1: xiangxian1(degree);break; case 2: xiangxian2(degree);break; case 3: xiangxian3(degree);break; case 4: xiangxian4(degree);break; default:break; } } void main(void) { unsigned char temp; unsigned cha