井字梁的计算及施工图处理（Calculation of well beam and construction drawing processing）.docVIP

井字梁的计算及施工图处理（Calculation of well beam and construction drawing processing） Calculation of well beam and construction drawing processing 1, cross beam and column to avoid way, adjusting the distance between the cross beam to avoid column; avoid cross beam connected reinforcement bearing at the cross beam and the column calculation result is prone to overrun; reduce the beam column joints under loads, because both stiffness and disparity a weak point that first destroy, due to cross beam from the column, close to the area frame of the need to further strengthen the post processing. 2, cross beam and the column to take anti method, and the pillar connected beams designed Dajing beams, the slim beam set in which form a structure size of cassion beam embedded, slim beam to transfer from large beam floor load, and then to the post. 3, the value of the cross section height of the right beam should be mainly controlled by the stiffness. In addition to considering the short span of the floor and the magnitude of the calculation load, the torsional rigidity of the surrounding supporting beam should be taken into account. 4, due to the force and deformation characteristics of the well beam floor, similar to the two-way slab, the well beam itself has the torsion component, so it is better to control the beam spacing within 3m. 5, well beam can generally be calculated by simply supporting end. 6, when there is a column around the well beam, the spacing between the well and the beam can be adjusted to avoid the column. The grid plate near the column needs to be strengthened. If it can not be avoided, it can be designed into the structure of the size of the well and the beam. 7 、 reinforced concrete beam is a kind of structural form evolved from reinforced concrete two-way slabs. The biaxial plate is a flexural member, and the corresponding plate thickness increases as its span increases. But the lower part of the slab is not taken into consideration by the concrete in the tension