110吨电炉余热回收系统安全运行规程（Safety operation regulation for waste heat recovery system of 110 ton electric furnace）.docVIP

110吨电炉余热回收系统安全运行规程（Safety operation regulation for waste heat recovery system of 110 ton electric furnace） Safety operation regulation for waste heat recovery system of 110 ton electric furnace System put into operation 1. Before the whole system starts, the operator on duty first checks whether the manual valves are opened, and whether the drum and regenerator levels are normal; 2 、 check and confirm whether the fan high voltage frequency conversion system is switched on, whether the control switch on the frequency converter cabinet panel reaches the remote position, whether the water pump, the valve and the instrument control power supply are electric or not; 3, start the main control room computer, check whether the normal operation of the system, the display screen, and the flue gas waste heat utilization process monitoring picture (picture), recovery and utilization of waste heat detection control screen, the monitor screen, fan alarm screen, display data, indicating whether the normal state parameters on the screen, switching between picture the mouse button, click on the corresponding button can enter and display; 4, under normal circumstances, the computer screen of the valve, pump control should be centralized (remote) control state; 5. When the system starts, make sure the electric furnace cover is in the swing state; 6, first check whether the inverter is ready, inverter without alarm signal, no fault signal, no accident of high voltage motor signal, click on the computer screen in the start button, the fan can be started, click the stop button, the fan stops running; In 7, the fan control screen has a low frequency input window and a high frequency input window, prior to the frequency set, when the furnace cover is screwed out, leaving the furnace, the low frequency wind machine to set a good rate of operation, when the furnace cover is screwed in, fan in order to design high frequency set operation. When the inverter fault signal or inverter alarm signa