cpu超频注意事项（CPU overclocking notes）.docVIP

cpu超频注意事项（CPU overclocking notes） CPU overclocking notes 1, Intel platform Because Intel all CPU are locked multiplier, so we can only through the promotion of FSB overclocking to. However, in too Intel processor overclocking, upgrade the FSB best with 5MHz to enhance the amplitude, if FSB increase to a certain extent when the system is not stable, can slightly increase the voltage. After all, for Intels CPU, a little more voltage, the effect is obvious. The main thing to mention here is that the motherboard supports the change of voltage, otherwise there is no room for overclocking. If you need to transfer the card, you should pay attention to choose or replace the voltage adjustment card is the best policy. First of all it is, the Prescott core of the Pentium4 pressure is very dangerous, because many sites have reported that pressure causes the Prescott burn, MSI motherboard supports Prescott CPU BIOS in the refresh, even blocked the CPU voltage regulation options, pressure will not burn down the visible Prescott Weakness lends wings to rumours. Therefore, I recommend you in overclocking Prescott core CPU, try not to pressure, and if you have to pressure overclocking, then the range is best not more than 0.1V. In addition, because is to enhance the FSB, great influence on other components, it is recommended that you try to get AGP and PCI frequency is fixed at 66/33MHz, not for the AGP/PCI fixed frequency set motherboard, the best use of 6 hours, if it fails, try again 5 points. For the DDR frequency purchase, preferred DDR and FSB synchronization (1:1) is set up, in case of failure considering 4:5 and several other DDR frequency settings, of course if your memory is DDR500 level and above, the choice of DDR and the FSB synchronization is the best choice. Of course, high frequency Pentium4, especially Prescott core processor heating capacity can not be ignored, so we had better choose an excellent radiator, and through the BIOS monitoring temperature function in o