pcl编程（PCL programming）.docVIP

pcl编程（PCL programming） LC is it easy to learn? Some people say, more people learn that. My view is that entry is easy and education is difficult. Easy entry, always easy way. A lot of people have bought books about PLC, and if I look at it from the beginning, I dont think 80% will work. Because the abstract and the void occupy the whole brain, a word of halo! Learn this thing to have programmable controller and simple programmer is good, if not, in a word, can not learn. Because it is impossible to verify the right and wrong. How to learn, my approach is straight to the subject. Practices are as follows: 1 、 understand the difference between ladder diagram and relay control principle symbol: Relay control element symbol principle diagram, a normally open contact and normally closed contacts and coils, in order to distinguish between them, such as KM, KA, labeling device KT to show different in the symbols on the edge, but the number of contacts is limited. In the PLC ladder diagram, there are normally open and normally closed contacts. On the same side, they can also mark X, Y, M, S, T and C to show different soft devices. Its biggest advantage is: the same mark contacts in different steps, can occur again and again. The relay can not achieve this goal. The use of the coil is the same, that is, different coils can only appear once. 2, programming elements: the programming element is divided into eight categories, X, Y as the input relay output relay, M and S as auxiliary relay relay, timer, T state for C, D for the counter data register and the pointer (P, I, N). About the function of various components, various versions of PLC books are introduced, it is not introduced here, but must understand the function of all kinds of components. The instruction for a programming element consists of two parts, such as LD (function meaning), X000 (element address), namely LD, X000, LDI, Y000....... 3 、 familiar with PLC basic instructions: (1) LD (take), LDI take reverse), OUT