恒吉rp82l 二次变频接收机失控保护的设置（Setting up of out of control protection for constant frequency rp82l two frequency receiver）.docVIP

恒吉rp82l 二次变频接收机失控保护的设置（Setting up of out of control protection for constant frequency rp82l two frequency receiver） A lot of friends die get factory manual reading is confused, its difficult to understand how to set (I also suffer). After repeated testing finally understand the setting method, the method to share with you: 1, open the remote control. 2, open the receiver indicator light flashes two times after constant light (i.e. normal connection remote). 3, the remote control throttle to you to set the size (generally 60% of oil well), automatic return function set to automatically return mode (such as Feiyu set to automatic return mode). 4, according to the receiver button for two seconds, indicator light flashes 3 times (2 times if the flash, then press the button again for 2 seconds to enter the set state). The observation of flashing lights, lights when the indicator light flashes three times longer after the rapid stage (when repeated three times, is actually slow flash three times after), this is the automatic protection mode (mode three), before the end of the three repeat before the press button to confirm the current state of the receiver (if you miss the waiting mode a model, by the cycle until the three mode button). 5, after the confirmation until the indicator light flashes two times after remain lit at the remote control receiver cannot. Restart the receiver after both set successfully. I bought the RP8D1 more headaches The merchant for the instructions (part): Set step on the power supply of the transmitter antenna and extension. The power supply to the receiver. The LED receiver will fast flash two. Press the search button on the receiver for 2 seconds. The LED will flash 3 times that the receiver is ready to establish a communication process (should be flashes 2 times, and then press the button again for 2 seconds) to observe LED, the receiver will continue to cycle in the 3 mode. So you can better see the flashing LED set in a dark environment.