除尘器文章（Dust collector article）.docVIP

除尘器文章（Dust collector article） Special function of dust removing skeleton As the pillar equipment of environmental protection industry, dust removal structure is playing an indispensable role. Environmental protection industry started relatively late in our country, and in the early stage of development, it did not receive due attention. In recent years, it has developed rapidly. Some domestic dust collector does exist some problems, such as electrical dust removal equipment for dust humidity and CO content requirements higher, once the humidity is insufficient or CO exceeds standard, often appear shutdown, lead to accident emissions. And a lot of bag dust collector have many problems, for example, cleaning equipment effectiveness is not high, the dust on the surface of the filter bag of set is difficult to peel, the dust resistance is high, resulting in the kiln smoke; some cleaning device, cleaning parameter calculation and design is not reasonable, difficult to peel off the surface of the filter bag on the dust; some serious air leakage, adding precipitator air too much, resulting in condensation, paste bag bag, dust remover can not be used; in addition, the temperature control measures and regulation of bag filter has been designed, makes the dust collector can neither prevent dewing at low temperature, and can prevent the high temperature burn bag. This is also a long-standing problem plagued many enterprises, affecting the normal production of cement enterprises. The 1 part: in the host skeleton and dedusting equipment after installation, should be the case and the ash bin and other components of the debris removal, check the transmission parts and injection of lubricating oil (grease), the reducer injection of HJ-30 or HJ-20 oil. 2 、 electronic control part: (1) electrical control and dust cleaning installation: A the switch on the three-way valve is normally opened and the contact point is connected with the indicator light. At the same time, connect the diff