usb接口线路（USB interface line）.docVIP

usb接口线路（USB interface line） USB interface circuit definition and graphical connection 2009-06-05 22:40 chassis front USB wiring definition First of all, or understand the chassis on the front line USB definition of each connection. The red line: (positive power supply wiring ID: +5V or VCC), the white line: a negative voltage data line (ID: Data- or USB Port), the green line: positive voltage data line (ID: Data+ or USB + Port), black: grounding (ID: GROUND) Definition of motherboard USB pin 1.POWER SW also called PW SW (this is the case the power switch cabinet for controlling on-off button on the motherboard), there will be a corresponding interface, can be inserted. If you do not understand can read the instructions, above the target is very clear (the same below). The positive and negative pole - never mind, dont burn anything. 2.RESET SW (chassis reset key) used to restart the computer. It also doesnt matter if the positive and negative poles are inserted. It doesnt burn things 3.HDD LED, also known as IDE LED, this is usually used to connect the hard disk, showing the hard disk working state. This plug is also still not related, but the hard disk light will not light, if not found, you can change the order 4.port + port - P- (some only standard P+ power indicator) the two needles will usually separate, could empty a shot. But some motherboards are linked together. Also need reference manual. Some chassis connecting line will do together, a space in the middle. Insert also never mind, if you open the computer the power does not light, change the order. This is the 5.speaker chassis speaker power, used to indicate the working state of all components. The user is usually two row, eight pin set, out of a needle, can be found in the motherboard manual, there will be some jumper on the motherboard, chassis plug and pull out it, online through a hole in the back is not inserted may be inserted in it. 6.AUDIO chassis front audio pin. In accordance with the instruction