场效应管的作用及测试（Function and test of field effect transistor）.docVIP

下载本文档

7
0
约3.07万字
约 37页
2017-09-01 发布于河南
举报
版权申诉

场效应管的作用及测试（Function and test of field effect transistor）.doc

1、原创力文档（book118）网站文档一经付费（服务费），不意味着购买了该文档的版权，仅供个人/单位学习、研究之用，不得用于商业用途，未经授权，严禁复制、发行、汇编、翻译或者网络传播等，侵权必究。。
2、本站所有内容均由合作方或网友上传，本站不对文档的完整性、权威性及其观点立场正确性做任何保证或承诺！文档内容仅供研究参考，付费前请自行鉴别。如您付费，意味着您自己接受本站规则且自行承担风险，本站不退款、不进行额外附加服务；查看《如何避免下载的几个坑》。如果您已付费下载过本站文档，您可以点击这里二次下载。
3、如文档侵犯商业秘密、侵犯著作权、侵犯人身权等，请点击“版权申诉”（推荐），也可以打举报电话：400-050-0827(电话支持时间：9:00-18:30)。
4、该文档为VIP文档，如果想要下载，成为VIP会员后，下载免费。
5、成为VIP后，下载本文档将扣除1次下载权益。下载后，不支持退款、换文档。如有疑问请联系我们。
6、成为VIP后，您将拥有八大权益，权益包括：VIP文档下载权益、阅读免打扰、文档格式转换、高级专利检索、专属身份标志、高级客服、多端互通、版权登记。
7、VIP文档为合作方或网友上传，每下载1次，网站将根据用户上传文档的质量评分、类型等，对文档贡献者给予高额补贴、流量扶持。如果你也想贡献VIP文档。上传文档

场效应管的作用及测试（Function and test of field effect transistor）

场效应管的作用及测试（Function and test of field effect transistor） Qualitatively determine the quality of field effect transistors and transistors, 2008-06-22, 00:23, and qualitatively determine the quality of field effect transistors First use the multimeter R * 10K block (built-in 15V battery), the negative form of the grid (black) (G), is a pen (red) ground source (S). Charging between the grid and the source is a slight deflection of the pointer at this time. Then use multimeter R * 1 Omega block, the negative probe connected to the drain (D), is the pen connected source (S), multimeter indication for a few ohms, the FET is good. Two. Judge the electric field of junction type FET The multimeter dial to R * 100 files, the red pen arbitrarily pick one pin, the black pen is connected to another pin, the third is suspended. If the hands have a slight swing, prove the third gate. To observe the effect is more obvious, also can use the body near or with fingers dangling feet, just to see the hands to make substantial deflection, that is left foot gate, the remaining two feet are the source and drain. Judge reason: JFET input resistance is greater than 100M, and transconductance is very high, when the grid open, the space electromagnetic field is easy to sense voltage signal on the gate, so that the pipe tends to cut-off, or tends to conduction. If the induction voltage is directly added to the grid, the phenomenon will be more obvious due to the strong input interference signal. As to the left hand greatly deflection, it means that the pipe tends to stop, increase the drain source resistance between RDS and drain source current decreases IDS. On the other hand, to the right hand large deflection, that pipe tends to conduction, RDS down, IDS up. But the hand toward what direction should be considered, the polarity of the induced voltage (voltage or reverse voltage) and the working point of the tube. Matters needing attention： (1) test shows that, when the hands with D, S insulat