雷达说明书2117.doc

1 RADAR OPERATION 雷达操作 1.1 Turning on the Power 开启雷达 The [POWER] switch is located at the left corner of the control unit. Open the power switch cover and press the switch to turn on the radar system. To turn off the radar, press the switch again. The screen shows the bearing scale and digital timer approximately 30 seconds after power-on. The timer counts down three minutes of warm-up time. During this period the magnetron (transmitter tube) is warmed for transmission. When the timer has reached 0:00, the indication ST-BY appears at the screen center, meaning the radar is now ready to transmit pulses. 电源键位于控制面板的左上角。打开电源盖、按下打开电源。再次按下关闭电源。电源开启后30秒屏幕显示方位圈、电子计数器，计数器倒计时3分钟磁控管预热时间。但计数器时间归零，屏幕中央显示“待机”，表示雷达已准备发射。 In the stand-by condition, markers, rings, map, charts, etc. are not shown. Further, ARP is cancelled and the AIS display is erased. 在待机的情况下，标志、距标圈、海图等将不显示。ARPA功能取消，AIS显示取消。 In warm-up and stand-by condition, ON TIME and TX TIME counts in hours and tenths of hour appear at the screen center. 在预热和待机的情况下，使用时间和发射时间键显示在屏幕中间（*.*H）。 1.2 Transmitter ON 启动发射机 After the power is turned on and the magnetron has warmed up, ST-BY appears at the screen center, meaning the radar is ready to transmit radar pulses. You may transmit by pressing the [STBY/TX] key on the full keyboard or roll the trackball to choose the TX STBY box at the bottom left corner of the display and then push the left button (above the trackball). The label at the left-hand side of the guidance box at the bottom right corner of the screen changes from TX to STBY 在电源打开、磁控管预热后，ST-BY显示在屏幕中间，表示已准备发射。按准备键或用鼠标选择屏幕左下角的发射准备框打开雷达 。 雷达显示 The radar is initially set to previously used range and pulse length. Other settings such as brilliance levels, VRMs, EBLs and menu option selections are also set to previous settings. 雷达的设定（量程、脉冲长度、亮度、活动距标圈、电子方位线、菜单选项等）为上次关机时的设定。 The [STBY/TX] key (orTX STBY box) toggles the radar between STBY and TRANSMIT status. The antenna stops in stand-by and rotates in