Control Valve Technical Specification ICEWeb（ICEWeb控制阀技术规范）.pdfVIP

Control Valve Technical Specification Control Valve Technical Specification Reference: “Control Valves – Practical Guides for Measurement and Control” edited by Guy Borden, Jr. and Paul G. Friedmann, 1998 edition published by ISA. Control Valve Technical Specification © 2000 by CCI. All Rights Reserved. This document has been produced by Control Components Incorporated, Rancho Santa Margarita, California based on subjects presented in the ISA Guide Control Valves - Practical Guides for Measurement and Control edited by Guy Borden, Jr. and Paul G. Friedmann, 1998 edition published by ISA and other published sources. The use of the letters ISA in this specification does not constitute an endorsement of this specification by the Instrument Society of America. Control Valve Technical Specification Throughout this specification, where the word “shall” is used to define a requirement, Seller must comply with the requirements. Where the word “should” is used to define a requirement, Seller may select an alternative and advise Buyer accordingly. 1 Scope This specification prescribes the minimum mandatory requirements governing the design, sizing, and selection of control valves. 1.1 Equipment and services furnished by the Seller shall include: 1.1.1 Design, fabrication, testing and delivery of all valves, complete with actuators and accessories to meet the requirements of this specification and the control valve data sheets. 1.1.2 All interconnecting instrument tubing and fittings between the valve actuator, positioner, and filter regulator. 1.1.3 Any special tools required for assembly, disassembly and maintenance. 1.1.4 Valve drawings and calculations, incl