Design and Implementation of Firing Circuit for （发射电路的设计和实现）.pdfVIP

International Journal of Computer and Electrical Engineering, Vol. 3, No. 3, June 2011 Design and Implementation of Firing Circuit for Single- Phase Converter Tirtharaj Sen, Pijush Kanti Bhattacharjee, Member, IACSIT , Manjima Bhattacharya so far as line commutated converters are concerned. In this Abstract—The theme of the paper is to design and paper we have designed to implement low cost firing circuit implement the firing circuit for a converter. The necessity of for a single phase line commuted converters. getting synchronized firing pulses for the gate of the thyristor is discussed. Out of many variety of firing circuits available, A. Thyristor its conduction the ideas behind are the two most popularly used control A thyristor or SCR is a four layer device having three circuits that are namely using ramp signal and using cosine junctions J1, J2 and J3. Essentially three terminals named signal. It shows how a cosine controls scheme work. Detail anode, cathode and gate are available as shown in Fig. 1 description and functioning of each block is explained along with the waveforms at the output of the blocks. Experimental (below) for external connections. Under the conditions a results obtained from oscillographic displays at important thyristor either conduct or not conduct, i.e., it allows current points of the circuits are included. In this paper, we fabricate a eith