Hard turning is six times faster than grinding （努力将是比磨快6倍）.pdfVIP

Hard turning is six times faster than grinding Case study: Eaton Fluid Power Significant cost savings loss was mainly incurred during and single-digit micron sleeve set-up and sometimes tolerances achieved represented as much as 30 per cent of a batch, which was Since June 2013, sleeves problematic as Havant is a high and spools for servo control mix, low volume production valves have been hard turned environment, so changeovers by Eaton Fluid Power, Havant, are frequent. in a robotically loaded CNC lathe built by the German firm, The automated lathe took Spinner, and supplied through over from two ageing grinding UK agent, Whitehouse Machine machines, an internal model for Tools. The high precision machining the inside diameters production cell has slashed of the sleeves and a centreless cycle times by up to 600 per model for plunge grinding the cent compared with grinding, outside diameters of the spools. reducing manufacturing costs, Capital investment in a single been involved in hard turning while accuracy and surface lathe, which will pay for itself in in a previous job and knew that finish have been maintained. 2.5 years, was significantly less competitors in the hydraulics than the cost of replacing two sector had adopted the process. An additional annual saving of grinders. This was not the case with more than £20,000 results from many staff members during the a significant decrease in scrap, Stephen