Selecting Tubing Materials for Power Generation （选择油管材料发电）.pdf

Selecting Tubing Materials for Power Generation Heat Exchangers Daniel S. Janikowski Plymouth Tube Co. – East Troy, WI Presented at the Southwest Chemistry Workshop (Irving, TX): July 28-31, 2003 Abstract A power plant engineer has many choices when selecting tubing materials for his condenser, feedwater heater or balance-of-plant application. The wide variety of stainless steel choices available (ASTM lists over 75 alloys) gives the engineer greater flexibility to choose the best candidate to meet budgetary constraints and still provide the performance needed for the lifetime of the plant. Unfortunately, upset conditions can be common in power generation, and these can result in premature unexpected failure of tubing and piping materials. These may include differences in operation modes from design, changes in water chemistry due to leaks in other parts of the system, corrosion from unexpected sources, impact of improper lay-up practices, and the effect of corrosion product transport to other parts of the system. The motivation to build modern combined-cycle power plants for the lowest cost per kilowatt has stretched the envelope for materials performance. This paper provides an overview on a number of factors known to cause failure of a tube or pipe material. Knowing the limitations of material is crucial when making a selection for a specific application. This paper helps to identify the factors that need to be considered when selecting a material. Properties compared in this paper include corrosion resistance, stress corrosion cracking potential, thermal and mechanical properties, erosion resistance, vibration potential, and temperature limitations. The property comparison guides are intended to be quick tools to assist the user in sele