Simulation of Wind Power based Induction （模拟风力发电基础归纳）.pdfVIP

International Journal of Science and Research (IJSR) ISSN (Online): 2319-7064 Impact Factor (2012): 3.358 Simulation of Wind Power based Induction Generator Kodi Suman1, TVV Pavan Kumar2 1, 2Global Institute of Engineering Technology, Hyderabad, India Abstract: This paper describes the performance comparison of a wind power systems based on two different induction generators as well as the experimental demonstration of a wind turbine simulator for the maximum power extraction. The two induction machines studied for the comparison are the squirrel-cage induction generator (SCIG) and the doubly fed induction generator (DFIG). The techniques of direct grid integration, independent power control, and the droop phenomenon of distribution line are studied and compared between the SCIG and DFIG systems. Both systems are modeled in Matlab/Simulink environment, and the operation is tested for the wind turbine maximum pow er extraction algorithm results. Based on the simulated wind turbine parameters, a commercial induction motor drive was programmed to emulate the wind turbine and is coupled to the experimental generator systems. The turbine experimental results matched well with the theoretical turbine operation Keywords: Doubly fed induction machines, field-oriented control, maximum power tracking, and wind power system. 1. Introduction tracking interface between generator and grid. Field-oriented control (FOC) is applied to both rotor- and stator-side The