Standard Test Method for Haze and Luminous （霾和发光的标准试验方法）.pdfVIP

Designation: D 1003 – 00 Standard Test Method for Haze and Luminous Transmittance of Transparent Plastics1 This standard is issued under the fixed designation D 1003; the number immediately following the designation indicates the year of original adoption or, in the case of revision, the year of last revision. A number in parentheses indicates the year of last reapproval. A superscript epsilon () indicates an editorial change since the last revision or reapproval. This test method has been approved for use by agencies of the Department of Defense to replace Method 3022 of Federal Test Method Standard 406. 1. Scope E 259 Practice for Preparation of Reference White Reflec- tance Standards3 1.1 This test method covers the evaluation of specific light-transmitting and wide-angle-light-scattering properties of E 284 Terminology of Appearance3 planar sections of materials such as essentially transparent E 691 Practice for Conducting an Interlaboratory Test Pro- plastic. Two procedures are provided for the measurement of gram to Determine the Precision of a Test Method4 luminous transmittance and haze. Procedure A uses a hazeme- 2.2 ISO Standards:5 ter as described in Section 5 and Procedure B uses a spectro- ISO 13468–1 Plastics—Determination of the Total Lumi- photometer as described in Section 8. Material having a haze nous Transmittance of Transparent Materials value greater than 30 % is considered diffusing and should be ISO/DIS 14782