Sulfuric Acid Pumps Peerless Pump（硫酸泵无与伦比的泵）.pdfVIP

Sulfuric Acid Pumps Sulfuric Acid is the largest tonnage inorganic chemical manufactured and is probably the most important, being the starting point for many other products. Concentrated sulfuric acid, as an industrial product, is manufactured and shipped as either 93 or 98.5% acid. Oleum is fuming sulfuric acid, containing excess combined sulfur trioxide, and is shipped as 20-65% oleum. The basic reaction for manufacture of sulfuric acid by the contact process is the combustion of sulfur with dry air to sulfur dioxide, catalytic conversion to sulfur trioxide, and absorption of the product in strong acid. The final products are 98.5% acid and oleum, while 93% acid is produced by dilution in the air-drying tower. Pump Model The Taber Series 1000 is the pump of choice. The preferred speed is 1800 rpm. We can supply a Series 8000, which has the added feature of a triple throat casing for reduced radial loads. The pump can also be operated at 1200 and 3600 RPM, consult factory for support. Pump Selection and Application Materials of Construction: All wetted parts should be per the attached selection guide: CI/316SS can be used for high concentrations and low temperatures or Hastelloy B should be used for higher temperatures and/or concentrations. Special two piece shafts might be required for longer settings, above 12 feet. The support plate can be 316SS cladded for extra protection. All hardware below the support plate should be 316SS. Most pumps are Vapor Proof Construction. Contact the factory for specific material selection. Bearing Materials: Bearing materials made of Glass-Filled Teflon (GFT) or Carbon Graphite should be used.