SURFACE ROUGHNESS ON METAL POWDER （在金属粉末表面粗糙度）.pdfVIP

Oct. 2014. Vol. 5. No. 05 ISSN2305-8269 International Journal of Engineering and Applied Sciences © 2012 - 2014 EAAS ARF. All rights reserved SURFACE ROUGHNESS ON METAL POWDER INJECTION MOULDING AISI 316L STAINLESS STEEL BY ABRASIVE BELT GRINDING 1BO-SUNG YANG, 2HSI-HSUN TSAI 1Engineer, Center of Manufacturing Technologies, Shin Zu Shing Co., Ltd., New Taipei City, Taiwan 2Associate Professor, Department of Mechanical Engineering, Ming Chi University of Technology, Taiwan 1 2 Email: hhtsai@.tw, loveandlikeashin@ ABSTRACT Grinding removes surface material to improve the surface by sandpaper to give a specific or desired roughness behind the grinding. The ultra-precision turning may enhance the surface roughness of the workpiece to Ra 10 nm, but the cost of this turning process is higher than the one of the traditional grinding and polishing processes. The wear devices such as the iwatch of Apple and Galaxy Gear of Sumsung use the stainless steel cases to increase the luster and the noble sense. The metal powder injection molding is therefore applied to fabricate the stainless steel cases in mass production. The grinding is essential for these MIM stainless steel cases to minimize the surface roughness and then eliminate the voids on the surface which are lead during the sintering of