SwitchMode Power Conversion Using the （SwitchMode权力转换使用）.pdfVIP

U-511 Switch-Mode Power Conversion Using the bq2031 The relationship of CPWM to the switching frequency, FS Introduction is given by: The bq2031 incorporates the necessary PWM control cir- Equation 1 cuitry to support switch-mode voltage and current regu- 0.1 lation, as required by its charge control function block. FS = kHz This application note describes how to configure the CPWM bq2031 in buck mode switching power supply topology. A methodology for phase compensation of the voltage where: and current feedback loops is recommended. A brief de- scription of the PWM control circuitry and phase com- CPWM is in µF. pensation criteria appears below, followed by a The PWM for either loop consists of a comparator discussion dealing with topology-specific issues. whose positive terminal is driven by the output of the sawtooth ramp signal, VS, while the negative terminal The Pulse-Width Modulator is driven by the output of an Operational Transcon- ductance Amplifier (OTA). The output is the control The bq2031 incorporates two voltage mode direct duty signal, VC. The output of each PWM is logically ORed cycle Pulse-Width Modulators, one for each control loop to generate a constant frequency pulse width modu- (voltage and current). A block diag