手机结构设计的一些心得（Some ideas about mobile phone structure design）.doc

手机结构设计的一些心得（Some ideas about mobile phone structure design） I just according to my knowledge and experience, write down some mobile phone design experience, everyone has own design ideas and norms, this is only my personal experience, I hope everyone can learn, also welcome the heroes of us, thank you!! Time: 2009-11-03 20:39:22 source: China mold video network Author: anonymous browsing: 462 submissions Stack structure design of mobile phone motherboard stacking I havent done, so I wont do, I can only talk about the whole structure design, the structure design of my mobile phone is divided into the following parts: Stacking, a structural engineer to understand: an accurate understanding of the meaning of stacking, get a new stacking, where stacking must understand this structure where the fixed buckle board, design, key space, ESD grounding protection and so on, we should have a clear outline. Of course, good engineers stacked he must be a good structural engineer, but often a good structural engineer to stack you will care for this and lose that. Therefore, when we review the stacking, the structural engineers from the structural design problems raised to improve the stacking. Review and communication two, ID: structural engineers get ID wrapped ID 3D drawing, graphic process diagram first to get the ID, analysis of the parts and remove after the process feasibility, or in the process of how to achieve the effect of ID, which need to communicate with the ID. Some of us can reach ID, but the possible structure of great risk, so dont blindly accommodate ID, to know a product quality finally to pursue you is the structural engineer responsibility, no one to say that ID is not, so is the structure decision ID, and not ID about our structure, of course we should try to save the will of the ID. Then, to check that each part has enough space for the structure, I dont say much about it. Here I am going to make a few suggestions for modeling the ID engineer: 1. the ID engi