示波器（Oscilloscope）.docVIP

示波器（Oscilloscope） The use of GOS-620 dual trace oscilloscope GOS - 620 dual track oscilloscope panel layout as shown in the following picture. Front panel instructions CRT display (2) INTEN: track and spot brightness control knob; (3) FOCUS: track focus adjusting button; (4) TRACE ROTATION: an adjusting button that parallels the horizontal track with the scale line; (6) POWER: power main switch, press this button to switch on the power supply, the power indicator light will shine, and then press the switch, when the switch is raised, then cut off the power supply. (33) FILTER: filter lens, so that the waveform is easy to observe; VERTICAL vertical deviation (7) (22) VOLTS/DIV: vertical attenuation select button, select the input signal attenuation range of CH1 and CH2 by this button, the range is 5mV/DIV~5V/DIV, a total of 10 files; (10) (18) AC-GND-DC: the input signal is coupled to select the button; AC: vertical input signal, capacitive coupling, cut-off DC or extremely low frequency signal input; GND: by pressing this key, the signal input is isolated and the vertical attenuator input is grounded so that a zero voltage reference signal is generated; DC: vertical input signal, DC coupling, AC and DC signal input amplifier. (8) (X) input: the vertical input of CH1, in the X-Y mode, the signal input for the X axis; (9) (21) VARIABLE: sensitivity fine tuning control, at least to the display value of 1/2.5. At the CAL position, the sensitivity is the gear display value. When the knob is pulled out (* 5 MAG state), the sensitivity of the vertical amplifier is increased by 5 times; (20) CH2 (Y) input: the vertical input of CH2, in the X-Y mode, the signal input for the Y axis; (11) (19) POSITION: the vertical position adjustment button of track and light spot; (14) VERT, MODE:CH1, and CH2 select vertical mode of operation; CH1 or CH2: Channel 1 or channel 2 is displayed separately; DUAL: set this oscilloscope to work in both CH1 and CH2 channels, and then switch the AL