自己动手做pcb（Do it yourself, PCB）.docVIP

自己动手做pcb（Do it yourself, PCB） Electronic enthusiasts in doing experiments or production, tend to make a PCB, then it is a headache, if to the factory proofing, costs are not cheap, so do it yourself, use glue, paint, draw knife and other methods, but the process is complex, time-consuming, and ineffective. You fill the line, but if you make a standard, good board, also it is Nabuchushou, do complex is not. Recently the Internet, through online communication, plus some of his own experience, find a plate making method fast and good and cheap, full cost just a one-time investment of 260 yuan, can make the board as like as two peas and computer design, both single and double, it can complete task in general, to introduce here: First of all, to the market to purchase a machine is specially used for pressing, documents, photos and plastic skin packaging machine, low price of only 220 yuan, up by A3 can format paper. Look for a few flat without tailoring impressions of the adhesive paper, only the paper, namely the side surface of the light yellow smooth. It is best to buy a special paper, the Internet has sold about 40 yuan, A4 format 100. As long as the above two items are purchased, the printing plate can be developed. In the computer, through the PROTEL99 and other circuit making software designed to print the territory, the design proposed to consider the following points: 1., the minimum line width of not less than 15mil is appropriate. 2. try to use SMD devices. Using SMD devices can reduce volume and improve scalability. Particularly advantageous is a substantial reduction in the amount of punch work. 1206 SMD chip resistors and capacitors are more suitable for manual welding, cross wire can be replaced by 0 ohm resistors. Good design, in the PROTEL99 print settings into a mirror print, a hollow pad printing, and then use the first laser printer will print in a plain paper, after check, cut a piece of paper printed board larger than the smooth face. On top of the