臭氧检测（Ozone detection）.docVIP

臭氧检测（Ozone detection） Ozone test.Txt, two men chase a woman, with shallow, will give up first. Two women chase a man, love will give up. You ~ - person), I do not believe even punctuation and China where 1 billion 300 million of the population could not communicate between man and woman. The detection methods of oxygen concentration can be broadly divided into three categories, namely, chemical analysis, physical analysis and physical chemistry analysis. 1. chemical detection 1. chemical detection 1.1 iodine method Iodometric method is the most commonly used method for the determination of ozone, China and many countries as the standard method for the determination of ozone gas, Chinas Ministry of Construction issued the ozone generator, ozone concentration, yield and power consumption measurement standard CJ/T 3028.2 - 94 is specified using the iodometric method. The principle is that strong oxidizing agent ozone (O 3) reacts with potassium iodide (KI) water solution to form free iodine (I 2). Ozone is reduced to oxygen. Equation of reaction: O 3 + 2KI + H 2 O = O 2 + I 2 + 2KOH The free iodine is colored in water, from low to high and pale yellow to deep red. The use of sodium thiosulfate (NaS 2 O 3) standard titration solution, free iodine into sodium iodide (NaI), the reaction end point for completely fade check. Equation of reaction: I 2 + 2Na 2 S 2 O 3 + 2NaI + NaS 4 O 6 Two, the quantitative relationship between the amount of O 3 reaction and the amount of NaS 2 O 3 consumed is 1molO, 3:2mol, NaS 2, O 3, and the ozone concentration C and O3 are calculated as follows: C O3 =40x3x1000/1000 (mg/L) In style: C O3 - ozone concentration, mg/L; A Na - sodium thiosulfate standard solution, ml; B - concentration of sodium thiosulfate standard solution, mol/L; V 0 - sampling volume of ozonation gas, ml. Operating procedures and methods refer to standard CJ/T3028.2 - 94. It is very convenient to measure the concentration of the standard generator. The volume of the ozon