重装windows后如何恢复与原linux的双重引导（After reloading windows, how to restore the dual boot with the original Linux）.docVIP

重装windows后如何恢复与原linux的双重引导（After reloading windows, how to restore the dual boot with the original Linux） LILO is a very small program that allows users to choose which operating system to boot when the system starts. By default, LILO is installed on the MBR of the main hard disk (the main boot sector), but when the Windows is reloaded, the Windows will overwrite the MBR of the main hard disk and flush the LILO program that was saved on the MBR. This article will introduce some ways that you can still access Linux after reinstalling the Windows. Preparation before reinstalling the Windows Before reinstalling the Windows, its important to have a Linux boot disk that can be used properly. Typically, the boot disk is the only way to get into Linux after installing Windows. Most Linux distributions will prompt users to create a boot disk during installation. After making the boot disk, we should test to make sure that the floppy disk correctly guides the Linux system (note that the floppy disk is not a very reliable storage medium). The test process is to insert the boot disk into the floppy drive, then log in with the Root user, enter the command shutdown -r now, and enter the carriage. If the Linux system is able to boot properly from the floppy disk, then you are ready to install Windows, you can skip the following, and see reinstall LILO directly. Method for making boot disk If your startup disk is out of order or you dont have a boot disk at all, make sure you fill it up before you install Windows. In addition, whenever you change the kernel of the Linux system, you also need to re start a boot disk. The easiest way to make a startup disk is to use the mkbootdisk command. However, before you use this command, you need to know the current version of the Linux kernel. View the Lilo.conf file to get the kernel version information, which contains the configuration information for LILO and the storage location of the kernel file. Before viewing the Lilo.conf file, you s