钢骨（Steel）.docVIP

钢骨（Steel） It is assumed that the axial force due to overturning moment of the shear wall directly bears the horizontal seismic shear force that can not be directly transmitted to the ground shear wall. Thus, the internal forces of the frame columns supported below the transfer floor are much larger than the results of the calculation analysis. The following measures are adopted: 1. Within the scope of the tower, the steel frame under the five storey and the reinforced concrete beam mixed structure (48 reinforced concrete columns) are used. As an important measure to solve the problem of high level switching and high overrun. 2, A, B tower podium floor roof panel, in tower of high mode, under longitudinal tensile pressure subjected to repeated and transverse shear stress is very complex. At the same time, due to the functional requirements of building use, opening a large hole in the central podium to set the elevator on the floor, greatly weakened. In view of this unfavorable factor, measures are taken to strengthen the section and reinforcement of the floor beam at the big hole, to increase the thickness of the floor and to add oblique reinforcement. 3, because the upper house is a butterfly plane, there are two transition beams in the individual parts of the transfer floor. According to clause 10.2.10 of the technical specification for concrete structures of high-rise buildings (JGJ3-2002), the vertical lateral resistance members (walls and columns) at the upper part of the transfer floor shall be directly placed on the main structure of the transfer floor. When the vertical arrangement of the structure is complex, the main beam supporting the shear wall and supporting the transition secondary beam and the upper shear wall, stress analysis should be carried out, the reinforcement should be checked according to the stress, and the reinforcement construction measures should be strengthened. It is difficult to adopt the frame supported main and secondary beam schemes