齿轮模数试题（Gear modulus test）.docVIP

齿轮模数试题（Gear modulus test） 1. helical gear meshing condition is correct ___ mn1=mn2=mn, alpha n1= alpha n2= alpha, n beta 1=- beta 2. 2. national standard, the general flat keys of the main size b * h, according to the diameter of the shaft selected. 3. in order to locate the part on the shaft, the parts on the shaft must be fixed axially and circumferentially. 4. the loss of power in gear transmission mainly includes the friction loss in the engagement, the friction in the bearing and the power loss of the lubricating oil. 5., the plane through the worm axis and perpendicular to the axis of the worm is called the middle plane, in the middle plane, the worm and worm gear meshing is equivalent to the meshing of the worm axis. The main failure modes of 6. worm drive are scuffing, pitting and wear. 7. parts on shaft axial fixation mainly adopts shaft shoulder, collar nut positioning, positioning sleeve, a spring washer and a fastening screw etc.. 8., according to the direction of bearing load or nominal contact angle, rolling radial bearings, thrust bearings. 9. common shaft hub is connected with key, spline connection and interference fit. 10., according to the gear system running, the gear axis position relative to the rack is fixed, can be divided into fixed axis gear train, epicyclic gear train. 11. the strength design of the closed type gear drive with soft teeth. Firstly, the main parameters and dimensions of the gear are determined according to the design of the contact fatigue strength and strength condition of the gear tooth surface. 12. common gear forms are gear shafts, solid, web and spoke gears. The 13. gear train can not only realize shunt drive, speed change and reverse drive, but also realize the synthesis and decomposition of motion. Two, the multiple-choice questions (1 points per game, 10 points) The idle wheel in the 1. gear train is often used to change the B. The transmission ratio of A. gear train, B. driven wheel steering, C. transmission distanc