The Deluxe Tenna Dipper QRP Kits（豪华Tenna七星QRP板）.pdfVIP

The Deluxe Tenna Dipper Design by: KD1JV Distributed by: Hendricks QRP kits, . The “Tenna Dipper” provides a simple means of determining the 50 ohm resonate frequency of an HF antenna or ATU (Antenna Tuning Unit). The small size and battery operation makes the unit ideal for use in the field. Features: ● Wide tuning range: ~3 MHz to ~30 MHz in two ranges ● Four digit LED frequency readout Usages: ● Eliminates the need for a transmitter and SWR bridge when: ● Trimming length of resonate dipole antenna. ● QRM free adjusting of antenna tuners ● Quickly adjust short, portable vertical antennas. How it works: A voltage controlled R/C oscillator generates a 5 volt square wave signal. This signal drives a resistive Wheatstone bridge. One leg of the bridge is the “unknown” resistance, the antenna. A wide band step up transformer is connected across the bridge to detect the signal produced when the bridge is unbalanced. This signal is farther amplified by a Darlington pair transistor amplifier. A high brightness LED is used to visually indicate the current in the collector of the amplifier. When the antenna impedance at the unknown leg of the bridge is equal to 50 ohms, the bridge is in balance and the LED will go out. Hence the name for this device, the Tenna Dipper, as we dip the brightness of the LED to find the 50 ohm match. Using the Tenna Dipper. Finding