TRANSIENT THERMAL ANALYSIS OF AN （瞬态热分析的）.pdfVIP

Proceedings of COBEM 2005 18th International Congress of Mechanical Engineering Copyright © 2005 by ABCM November 6-11, 2005, Ouro Preto, MG TRANSIENT THERMAL ANALYSIS OF AN INDUCTION ELECTRIC MOTOR Cassiano Antunes Cezário WEG Industries – Motors (Jaraguá do Sul, Santa Catarina – Brazil) / Federal University of Santa Catarina - UFSC cassiano@.br Marcelo Verardi WEG Industries – Motors (Jaraguá do Sul, Santa Catarina – Brazil) / Federal University of Santa Catarina - UFSC marcelov@.br Samuel Santos Borges WEG Industries – Motors (Jaraguá do Sul, Santa Catarina – Brazil) samuelb@.br Jonny Carlos da Silva Federal University of Santa Catarina - UFSC (Florianópolis, Santa Catarina – Brazil) jonny@emc.ufsc.br Amir Antônio Martins Oliveira Federal University of Santa Catarina - UFSC (Florianópolis, Santa Catarina – Brazil) amirol@emc.ufsc.br Abstract. This paper presents a thermal circuit model to simulate the behavior of an electric motor during the transient duty leading to steady-state operation under rated load. The proposed model allows the calculation of the temperature distribution in the radial direction of the electric motor, from the shaft inside to the motor frame surface. Several heat sources inside the motoras well as the heat conduction and the thermal contact resistances have been considered. The surface convection heat transfer inside the motor and at its external surfaces is modeled by using heat transfer coefficients. In the longitudinal direction, only the convection resistances inside the motor were considered. Due to its flexibility and ease of implementation, the software AMESim was used as the platform for modeling and simulation. The experiments h