Writing Simple Spice Netlists Hydrus（写简单的香料网表水蛇座）.pdfVIP

By Joshua Cantrell Page 1 jjc@ Writing Simple Spice Netlists Introduction Spice is used extensively in education and research to simulate analog circuits. This powerful tool can help you avoid assembling circuits which have very little hope of operating in practice through prior computer simulation. The circuits are described using a simple circuit description language which is composed of components with terminals attached to particular nodes. These groups of components attached to nodes are called netlists. Parts of a Spice Netlist A Spice netlist is usually organized into different parts. The very first line is ignored by the Spice simulator and becomes the title of the simulation.1 The rest of the lines can be somewhat scattered assuming the correct conventions are used. For commands, each line must start with a ‘.’ (period). For components, each line must start with a letter which represents the component type (eg., ‘M’ for MOSFET). When a command or component description is continued on multiple lines, a ‘+’ (plus) begins each following line so that Spice knows it belongs to whatever is on the previous line. Any line to be ignored is either left blank, or starts with a ‘*’ (asterik). A simple Spice netlist is shown below: Spice Simulation 1-1 *** MODEL Descriptions *** .model nm NMOS level=2 VT0=0.7 KP=80e-6 LAMBDA=0.01 vdd *** NETLIST Description *** R1 M1 M1 vdd ng 0 0 nm W=3u L=3u in R1 in ng 50 3µ/3µ 5V + Vdd ng