cad图导入photoshop（CAD图导入PS图象处理软件）.docVIP

cad图导入photoshop（CAD图导入PS图象处理软件） Self summary: 1. settings: file / drawing instrument manager / add plotter wizard / next / my computer /Adobe/postscript level 2/ next / print to file / next to final completion This will set the OK. (also try, postscript level 1 virtual printing the same effect) The use of postscript level 2/ 2.: drawing size file / print / plotter name A3 (420*297) / print range choose print window print / print / offset center proportion with drawings, graphic units selected mm / horizontal / direction selection can then determine the package into a *.eps map. 3.ps processing: after you import PS, you can copy the layer, change the color, use the lasso tool, and pay attention to the layer when you fill it. CAD diagram import PHOTOSHOP The introduction of CAD to PHOTOSHOP is a very old problem, and the solution is virtual printing! Heres a step by step (for the convenience of everyone, both in English and Chinese, with brackets in English): 1. Open the Printer Manager (plottermanager) under the file (file) menu. 2, run the printer add Wizard (Add-A-Plotter Wizard). 3, click on next next, in the right option, select my My (Computer), continue next, enter the Plotter Model printer select page. 4, on the left side of the vendor (Manufacturers) and select raster file format (Raster File Formats), this is we can see on the right side of the model (Model) in the list of many kinds of familiar graphics format, I used to use JPG format, select the independent JPEG grouping (Independent JPEG Group JFIF) , click next (next), until the completion of. In this way, we can output the CAD graphics bit JPG format later. Next, lets see how to use it. 5, with CAD do a picture, we open the file (file) menu under the print (plotter). In the print dialog box, select the Independent we just installed JPEG Group JFIF on the type of printer, the print to file (plot to file) and add the path name of the file, the file is a graphical editor in Photoshop. In the page setup, s