ping详解（平详解）.docVIP

ping详解（平详解） The role of Ping The purpose of Ping is to detect the network along with the situation and analyze the network speed, but what does it show through? First of all, you should understand some parameters of Ping and return information. Here are some of the parameters for PING: Ping [-t] [-a] [-n count] [-l length] [-f] [-i ttl] [-v tos] [-r count] [-s count] [-j computer-list] [-k computer-list] [-w timeout] destination-list | -t Ping specifies the computer until it is interrupted. -a Resolves the address to the computer name. -n count Send count the specified number of ECHO packets. The default value is 4. -l length Sends a ECHO packet containing the amount of data specified by the length. The default is 32 bytes; the maximum is 65527. -f Send the dont fragment flag in the packet. Packets are not segmented by the gateway on the route. -i TTL Set the survival time field to the value specified by ttl. -v TOS Set the service type field to the value specified by tos. -r count The routing of outgoing and returned packets is recorded in the record routing field. Count can specify at least 1 units and up to 9 computers. -s count Specifies the timestamp of the hop count specified by count. -j computer-list Routing packets using the computer list specified by computer-list. A continuous computer can be separated by an intermediate gateway (routing sparse sources), and the maximum number of IP allowed is 9. -k computer-list Routing packets using the computer list specified by computer-list. A continuous computer cannot be separated by an intermediate gateway (routing strict sources), and the maximum number allowed by IP is 9. -w timeout Specifies a timeout interval, in milliseconds. Destination-list Specifies the remote computer to ping. Pings return information is Request Timed Out, Destination Net Unreachable and Bad IP address, as well as Source quench received. Request Timed Out, this information indicates that the host of the other party can reach the TIME OUT,