工作接地与保护接零的区别与计算（Difference and calculation between work grounding and protection zero connection）.doc

工作接地与保护接零的区别与计算（Difference and calculation between work grounding and protection zero connection） Difference and calculation between work grounding and protection zero connection.Txt This article is contributed by ADDZB DOC documents may experience poor browsing on the WAP side. It is recommended that you first select TXT, or download the source file to the local view. Work earthing and protection zero connection First, the grounding is now widely used in the summer of three and four wire power supply system, the neutral point of transformer is directly grounded, the ground called ground work. From the distribution transformer (or generator) of the neutral point line called the line (or zero). The three-phase voltage between three line four wire end is 220 volts, called phase voltage for lighting or power. Why small single-phase neutral point three-phase four line supply system generally connected with earth? It is this: (a) can be quickly cut off the fault equipment. In ungrounded power generation system, a phase grounding, grounding current is very small, not enough to make the protection device to removal of faulty equipment. In the neutral point of power system directly grounded in single-phase grounding, will cause a large single-phase grounding current protection device can make rapid action, cut In addition to equipment fault. (two) reduce the electric voltage of human body is exposed. In neutral grounded system, when a person is, and on another, the human body with the voltage is 380 volts line voltage. But the system of neutral point grounding, when people the body touch phase, with the voltage of 220 volts. (three) to reduce the power line and the insulation level of electrical equipment to reduce the cost. In the neutral grounding system, each the voltage is the voltage, so the power line of the system and according to the phase voltage to design. The insulation level of the metal shell or the conductive parts of electrical equipment to reduce the cost. B