桥梁嫁接（Bridge grafting）.docVIP

桥梁嫁接（Bridge grafting） Code for safety operation of bridge erecting machine 1. the operator of the bridge erecting machine shall be trained by some operators to understand the mechanical structure and performance of the bridge erecting machine and the operation of the familiar beam erection method and through hole construction method. Must have enough sleep, work is not allowed to doze off, drink prohibited hanging work, high-altitude work must be fastened with seat belts. 2. check whether the formation of hanging beam rail transportation truck and heavy compaction, can only use low gear to start and run; transportation truck beam, and someone must go hand in hand, and pay attention to the stability of the rail box girder, box girder to prevent dumping. Transport vehicle on the box girder Liangping, if not immediately start and run to death with flat clips. 3. beam feeding attention when car or gantry crane and bridge machine main beam trolley longitudinal shift speed difference. When a beam flat car or a main truss is moving, a warning signal must be issued when someone is on the running line. 4. beam feeding must be carefully checked before the main beam and the front bracket, guidance of each part is locked and plug pins, preventing pin, avoid the front bracket support cylinder lock pin in place not loaded, check plug pad, sleeper and track and whether the connecting plate installation requirements. 5. before lifting, check whether the operating mechanical and electrical system is reliable, the motor and brake are flexible and reliable, and the limit switches and stroke switches shall be checked in case of no load. 6. before lifting should be unified command signal, lifting, signal and command staff from operating personnel by the operating personnel should be issued in the confirmation of the interrogation signal, command signal and command intent, to drive. 7. when the bridge erecting machine is operated, the control button shall be reasonably controlled. Beside