单片机部分程序--单片机的c语言应用程序设计.docVIP

················老师给的程序·················· 第一章 1-32 ORG 0000H LJMP START ORG 0100H START: MOV R2,#00H MOV R1,#20H LOOP: MOV A,@R1 JZ ZERO INC R1 CJNE R1,#51H,OVER JMP LOOP ZERO: INC R2 MOV 51H,R2 JMP LOOP OVER: SJMP $ END 1-34 ORG 0000H LJMP START ORG 0100H START: MOV DPTR,#1FFFH LOOP: INC DPTR MOVX A,@DPTR PUSH DPH PUSH ACC MOV A,DPH ADD A,#10H MOV DPH,A POP ACC MOVX @DPTR,A POP DPH MOV A,DPH CJNE A,#21H,LOOP END AD转换 ADC0809 #include absacc.h //绝对地址访问头文件 #include reg51.h #define IN0 XBYTE[0x7FF8] //通道0的地址 sbit ad_busy=P3^3; //AD转换结束标志 void ad0809(unsigned char *x); //AD转换函数,变量x为AD转换结果的指针 unsigned char ADC0809(unsigned int nADAddrBase,unsigned char chChannel); main() { unsigned int data i; static unsigned char data ad[8]; // ad0809(ad); for(i=0;i8;i++) { ad[i]=ADC0809(0x7FF8,i); } } void ad0809(unsigned char *x) { unsigned char i,j; // unsigned char adstate; unsigned char xdata *ad_adr; //指向外部存储空间的指针 ad_adr= IN0; //获得AD转换通道0的地址 for(i=0;i8;i++) { *ad_adr =0; //启动AD转换 for(j=0;j2;j++); //延时，EOC在AD转换启动后10us行变成低电平 // while((adstate=P30x08)==0x00); //等待AD转换结束 while(ad_busy==0); //等待AD转换结束,AD转换结束后EOC变高电平 *x=*ad_adr; ad_adr++; x++; } } //返回值为无符号字符型，变量分别为AD转换器的基地址，AD转换器的模拟通道 unsigned char ADC0809(unsigned int nADAddrBase,unsigned char chChannel) { unsigned char i,chADResult; unsigned char xdata *pADChannel; pADChannel=nADAddrBase+chChannel; *pADChannel=chChannel; //启动AD转换 for(i=0;i2;i++); //延时，EOC在AD转换启动后10us行变成低电平 while(ad_busy==0); //等待AD转换结束 chADRes