analysis of cracks in mass concrete construction control strategy analysis（分析大体积混凝土施工的裂缝控制策略分析）.docVIP

Analysis of cracks in mass concrete construction control strategy analysis [Paper Keywords] large volume of concrete construction in winter thermal insulation thermal stress cracking [Abstract] With the development of China’s construction industry, high-rise buildings, high-rise buildings continue to emerge, continue to invest in construction of various large venues, high-rise buildings of the box foundation or raft foundation has a large volume of concrete structure, but also often layer of deep beams and conversion, conversion beam, these structures made of concrete construction technology a higher demand, the construction enterprises in the specific construction process, there are often cracks, and in recent years increasing. A total construction area of ??140,000 m2, according to the project schedule, the concrete foundation is the winter of mass concrete construction, where A landlord on the ground floor, 29 floors and 2 underground floors deep concrete pit for the C40P8, the deepest pit of concrete up to 6.0 m, one-time casting about 2500m3, B landlord on the ground floor, 44 floors and 2 underground floors deep concrete pit for the C40P8, the deepest pit of concrete up to 6.9m, one-time casting about 4500m3. In this paper, the project on the large volume of concrete pouring common crack control issues more in-depth discussion. 1 mass concrete temperature and temperature stress calculation 1.1 the maximum temperature rise within the concrete The internal temperature of the concrete foundation slab of the center of the peak temperature rise of the temperature rise is generally slightly less than the adiabatic temperature rise, usually resulting in about 3d after concrete pouring, no warming since stabilized, and gradually cooling due to maximum temperature rise of concrete within 69 ℃, so the concrete surface temperature was controlled at around 44 ℃, so the concrete both inside and outside temperature does not exceed the specification of 25