issue log（问题日志）.docVIP

issue log（问题日志） According to the recent problems, the PLC program made the following changes 1, according to the rules of WBS will not go fast if the car spare parts, car or other vehicle spare parts need to go fast, the car does not reach the H5 point before the HMI screen go fast please Liu Dengfeng artificial selected, according to the new annex table TAG binding. Such as spare car has entered the WBS, need to release only manual drive, the function of the existing; 2, add delete queue information according to the station, please press the new Liu Dengfeng annex table TAG binding; 3, in order to avoid the repetition of the OrderID, the UnknownOrderItem variable to a local variable for each program in the; 4, RFID site only vehicle in place, too little information is available for manual input, only the vehicle in place, and the read / write failure alarm case, read / write manual is valid; 5, the establishment of the engine number buffer queue; 6, Z2_1 RFID moved to the elevator, if the point is HOLD car, will give the machine shipped release signal back to Z1, go back to the way to Z1 vehicle; The 7 and final assembly line in the repair area car line; 8, total queue length increased to 100 No matter the car after the car went to WBS serial number size H5 to H8 after the traffic jam H8 H5 back around. Z3 interior line Z4 interior line Z5 chassis line Z7 chassis line Z8 final assembly line Z9 test line The Z10 line in the rain Z11 route Z12 No. 1.298 car PBS, car ORDERID is not correct, we must ensure that no problem What Feiyu, ensure this week is no longer such a problem, even when the manual in PLC changed data but also to ensure that the final out of the ORDERID is correct. Feinikesi switch 2. assembly plant main control cabinet to replace Feinikesi Gery, the switch needs to be replaced, the original always appear off the net The 3. painting workshop to ensure that this week is not a big problem Wu Ming, to carry out inspections at various points 4. welding wo