jrockit性能调优（jrockit性能调优）.docVIP

jrockit性能调优（jrockit性能调优） A brief introduction of.JRockit tuning JRockit is an adaptive JVM, it can automatically adjust themselves to adapt to the underlying hardware, so its optimization mainly concentrated in some humanintervention parameters, for example: how to use JRockit RAM to partition etc.. JRockit is a group of non standard -X startup options, we can use it to adjust the JVM. JRockit there are two main groups of subsystems can be optimized memory management system (including garbage collection) and thread system. In the memory management subsystem, there are a lot of optimization work that can be done. Two.Tuning WebLogic JRockit JVM 1. set the initial heap size Can use -Xms:sizem to set the initial heap size, if the -Xmx value is less than 128MB, -Xms is the default value of 16MB; if the -Xmx is greater than 128MB, while the -Xms default for physical memory 25%, the maximum is not more than 64M. Example： -Xgc:gencon -xms:64m -Xmx:64m myClass 2. set the maximum heap size You can set the maximum heap size by -Xmx:sizem. Under IA32 framework, because the maximum memory address space for each process of the operating system is 1.8G, so the maximum heap size shall not exceed 1.8G. In the IA64 framework, there is no restriction on 1.8G. If your JAVA application appears Out of memory runtime errors, you need to adjust the maximum heap size. If you do not set the maximum heap size, the default value is: 1. if -Xgc:gencopy is set, the maximum heap size is min{400, *75%} of physical memory; 2. if -Xgc:gencopy is not set, the maximum heap size is min{1536, *75%} of physical memory; The best hand to the maximum heap size of physical memory (1024M) 75%: -Xgc:gencon -xms:64m -Xmx:768m myClass 3. set the size of the Nursery You can use -Xns:size to set the size of the Nursery, we need to guarantee the garbage collection pause time (garbage collection-pause) as short as possible at the same time, as far as possible to increase the size of the Nursery, which is especially