k-6x设置（K-6x settings）.doc

k-6x设置（K-6x settings） KDS K-6X 2.4GHz remote control helicopter set The key function of K-6X, UP and DN button to select the set pattern and the column, changing the parameters through the INC or DEC button, which shut down the remote control settings. System settings: At the same time, press the UP and DN button, open the transmitter power, enter the system setup. The use of INC or DEC to change the aircraft type helicopter mode, LED will display S1 HP3 Press DN button once, set the lever type, 52 D1 for the Japanese hand 52 D2 for the United States to hand. Click DN button two times, select the parameters of 1-5 model storage, selection can be called a good save settings. After setting off, the transmitter power settings will be saved before. 1. and the rudder set: Turn on the transmitter power, press the UP and DN button once, and the steering gear set 6 channel. The general is set to 450: The first channel: REV aileron Second channel: lifting NOR Third channel: NOR accelerator Fourth channel: NOR rudder Fifth channels: the gyro sensitivity NOR Sixth channel: pitch NOR Of particular note is that the KDS K-8R 2.4GHz receiver K-6X supporting the third channel is the accelerator, the initialization must unplug the motor line, or the removal of a large paddle, avoid setting error of the third channel reverse opening caused 100% throttle, very dangerous! 2. steering gear travel set: At the same time, press the UP and DN button for two times, the steering gear stroke 6 channels set up the general all with a default value of 100% can be. Love flight can be more flexible, in addition to the fifth channel (the gyro sensitivity) outside the travel channel, are set to 120%. 3. servo tune settings: At the same time, press the three UP and DN buttons, auxiliary steering gear tune settings (neutral point) All channel factory default value is 0, according to the steering rocker level, press the UP and DN button to select the channel, INC or DEC button to fine tune the position,