mount ntfs和fat32分区详述（mount ntfs和fat32分区详述）.docVIP

mount ntfs和fat32分区详述（mount ntfs和fat32分区详述） First, the most basic commands; 1, check the disk partition of the command fdisk -l; For example: [root@localhost beinan]# /sbin/fdisk -l Disk /dev/hda:, 80 GB, 80026361856 bytes 255 heads, 63 sectors/track, 9729 cylinders Units cylinders of = 16065 * 512 = 8225280 bytes Device Boot Start End Blocks Id System /dev/hda1 * 176561448317 HPFS/NTFS /dev/hda2 766280516386300 C W95 FAT32 (LBA) /dev/hda3 28067751397287455 Extended /dev/hda58193118+ 83 Linux /dev/hda6 382651001024140683 Linux /dev/hda7787153+ 82 Linux Swap / Solaris /dev/hda8 519966571171938683 Linux /dev/hda98787523+ 83 Linux Through the above we can see that the /dev/hda1 NTFS format is FAT32 format; /dev/hda2; 2, the mount command; Is to partition the mount command, if the kernel supports it, almost all of the mount commands can mount the file system, such as ReiserFS; ext2; ext3; NTFS; FAT32; JFS; in the Linux system, we have mainly used ReiserFS; ext3; ext3; in Windows system, we use the NTFS; FAT32; FAT; Mount hard disk partition: Mount -t file format -o option to partition the mount point directory name That may be a novice do not understand, what is the file format, what is the mount point directory name, we have a partition is loaded into the Linux, is not to have a store in place? For example, we put the /dev/hda1 mounted to the /mnt/winc directory; first of all we want to see is not whether winc exists in the /mnt project building book without winc; we must build a mount point directory name; of course is just named, the best use of English; For example in the back, novice brothers first know about this on the line; 3, the DF -lh disk usage command; this important; [root@localhost beinan]# DF -lh Filesystem has been available for volume% mountpoints /dev/hda8 11G 5.9G / 4.5G 57% /dev/shm 236M 0 236M 0% /dev/shm /dev/hda1 5.9G 3.2G 2.7G 55% /mnt/winc /dev/hda2 16G 8.1G 7.7G 52% /mnt/wind /dev/hda5 7.9G 5.8G 2.1G 74% /mnt/slack