pcb制版工艺流程（PCB plate making process）.docVIP

pcb制版工艺流程（PCB plate making process） The PCB plate making process With the continuous development of label printing industry, has developed from the previous work to the ordinary color multi-color, sticker printing presses from sheet to automatic roll paper color printing. There are two kinds of technology for adhesive printing machine printing plate: flat and round applanation. Flat plate is used in hard and soft base base (polyester base) can be used to select the plate only with circular applanation polyester base plate, in order to achieve the best printing effect. The resin version of the plate making process. First introduce the plate making equipment. Resin plate making machine is composed of vacuum pumping, exposure, washing and drying system composed of four. Light plate making machine is usually black lights side-by-side, the light output power of about 360nm. Plate making machine vacuum to make the film and plate tightly, resin version after exposure will not be distorted, making machine version of the system is composed of a stainless steel washing tank and moderate brush and motor, washing version of two-way plane rotation. Plate making machine dryer requires uniform heating, good circulation, automatic constant temperature device, to avoid overheating. The 1. film production The film produced by the camera, or use the computer typesetting, laser Phototypesetting publishing. The picture is usually Yin Yaomo face to see is the picture Yin (negative). The transparent part film density is less than 0.05, light shielding part density greater than 3. If less than this standard, will lead to exposure to UV penetration film, the graphic part appears not to the end of the flushing phenomenon. Please do not crease film. The color line usually live electrical extension, or imagesetter film publishing. 2. printing process (1) exposure The first version of the materials according to the film size cutting plate, preferably greater than 2-3mm film, vacuum membrane mus