rssi告警（rssi告警）.docVIP

rssi告警（rssi告警） 1: in the CDMA2000 indoor distribution site, as long as the main amplifier site most of the site appears RSSI is too high, I do not know how to determine the output power to put dry to reach a desired value, eliminate the alarm. The base station sector antenna problems, or there is a reverse interference. The reason may RSSI abnormal phenomenon RSSI (low main points) in long time RSSI less than about -113dBm, do not change with the increase of load and the quality problem of the project (including from the antenna to each joint of TRX contact is not good), hardware failure (such as TRX, CDU, power amplifier, antenna fault etc.). RSSI (high main points) in long time RSSI is higher than -93dBm or higher than the quality problem of -93dBm project in a certain period of time (jumper joint production is not standardized, jumper damage etc.), joint water traffic, leading to high setting Abis or FMR parameters (registration and insufficient resources, access to information is unreasonable), external interference. RSSI diversity has big differences between the two sets of main (sub) RSSI long time is above 6dB or RSSI diversity contrast alarm, TRM main (sub) set the quality problem of receiving alarm engineering (single jumper connection is not good, etc.), diversity antenna standing wave bypass switch setting error and external disturbance The engineering quality problems, joint water, traffic leading to high Abis or FMR resource is not enough, parameter setting problem of external interference The 2:CDMA2000 base station reverse link RSSI alarm is what kind of trouble? The equipment is ZTE BS8800, only one sector of the alarm. The base station sector antenna problems, or there is a reverse interference. If the DO is opened, intermodulation interference, changing the base station antenna board jumper, the sector, various joint inspection. Share]RSSI main collection diversity RSSI definition: RSSI (Received Signal Strength Indication) received signal strength