s700k集中检修（S700K centralized maintenance）.docVIP

s700k集中检修（S700K centralized maintenance） A switch machine, internal maintenance 1. cover free opening and closing, waterproof, dustproof performance is good, flexible and effective lock; Stop switch 2. switch lock on-off power performance, power, a baffle can effectively prevent the insertion of crank crank gear. When the switch is off, the smooth insert crank crank gear. Once the power is cut off, without artificial restoration shall be connected to the circuit, the crank shaft gear ring without shedding phenomenon; 3. normal conversion switch, ball screw moves smoothly without noise, good effect of friction connector; 4. switch two upper and lower detection rod without upper and lower lips and around the phenomenon of migration, wear fork type connector pin hole is not greater than 1mm; 5. speed switch, power function; 6. ball screw rod, and action detection rod, gears, locking bolt, iron, etc. shall be lubricated version control; The gap adjustment 7. detecting rod should be indicator of alignment between detection rod gap markers for rail, rail traction first switch machine point from the 1.5 sides of soil 0.5mm, the switch machine traction point from the 2 sides of soil 0.5mm, and between the internal and external machine; The 8. part screw, anti Sonka good; the terminal line is good, no loose; No foreign body inside the 9. switch machine. Two, external locking device maintenance and installation The 1. parts installation firm, no loss, fracture, fracture phenomenon, the screw take looseproof measures; 2. various parts to keep clean, oily, no rust; 3. pin bar open momentum should not be greater than 0.5mm, other parts are not greater than 1mm; The 4. lock hook on the horizontal axis with good effect, can flexibly adjust the lock hook angle. Lock iron, locking frame without crack, the lock hook pin and pin hole should be connected with the iron rail gap 0.5mm; The 5. locking rod limiting groove and a limit screw (PIN) concave wear depth is not greater than 1mm;