世嘉保养（Sega maintenance）.docVIP

世嘉保养（Sega maintenance） Correct maintenance safety through the running in period of Sega First, the running in period 0-3000 km, we put this stage into the running in period, this is an important period of vehicle running. Because the car in front of the factory have been running cold, but after all, engine, gearbox, drive system is working at a temperature condition, and these parts are made of metal material, the processing precision of the factory and then high metal will be under the characteristics of expansion and contraction, change. This makes running has become a necessary link. In the 0-3000 km run in period, pay attention to control the speed, do not let the vehicle speed is higher than the maximum speed of 2/3 is good, which is about 6000 to 2/3, which is not more than 4000. Another point is that dont always keep a long time running speed, because it can not achieve all running in all speed range effect, will cause the running mileage count, but the effect is not good in the. During this period, I suggest you to take into account all the road, there is a loop, congested road, a bumpy road, the shift should be timely, what speed will use what file, follow 2000-2500, 2500-3000 shift can be, this can be a more comprehensive running. Second, high speed oil change In fact, after the car 2000 kilometers can improve the speed of appropriate, when up to 3000 kilometers, can consider pulling speed, by comparing the harsh conditions of running, to achieve better condition. After the general state of 3000 kilometers of running, the engine has been close to the best state. Pull speed is greater in that engine load conditions, further adjustments. Because the vehicle is not only produced, we slow down, so we need to make the engine and all components at higher temperature, the final run in high stress situations, in order to determine the stability of the vehicle, our daily driving will also have a small amount of time over conventional driving. Method of pulling spee