中断号及interrupt和using（中断号及中断和使用）.docVIP

中断号及interrupt和using（中断号及中断和使用） A, interrupt External interrupt 00 T0 timer 1 External interrupt 12 T1 timer 3 Serial port 4 Two, interrupt and using in the C51 interrupt Including the basic structure of the MCU 8051 series: 32 I/O port (4 group 8 bit port); two 16 bit timer counter; full duplex serial communication; 6 interrupt sources (2, 2 external interrupt timer / Counter interrupt, 1 serial input / output interrupt, interrupt priority level two); 128 the built-in RAM 64K byte byte; independently addressable data and code. Interrupt occurred, MCU turned to the 5 interrupt at the entrance of the interrupt service and then execute the corresponding processing program. Interrupt address program entrance by the compiler in the interrupt vector, the interrupt vector at the lowest address located in the program code, note the serial input / output interrupt sharing an interrupt vector. 8051 the interrupt vector table as follows: Interrupt vector interrupt source The power on reset 0000H External interrupt 0 0003H Timer 0 overflow 000BH External interrupt 1 0013H Timer 1 overflow 001BH Serial port interrupt 0023H Timer 2 overflow 002BH Direct access to register and port Definition SFR P0 0x80 SFR P1 0x81 SFR ADCON; 0xDE Sbit EA 0x9F operation ADCON = 0x08; P1 = 0xFF; Io_status = P0; EA = 1; In the use of the interrupt keyword 1, will automatically generate the interrupt vector Not in the ISR and other background cycle code (the background loop code) shared local variables Because the connector will reuse these variables at the position of RAM, so they will have different meanings, depending on the current use of different function Reuse variables of RAM will be important to a limited 51. Therefore, these functions in order to perform a certain hope without interruption. Timer0_int (interrupt) 1 using 2 { Unsigned char temp1; Unsigned char temp2; Executable C statements; } The interrupt statement (8*n3), vector generation in here, the digital n is interrupt after parame