机电一体论文.doc

摘 要 本设计的灭弧室压装机为机电一体化的半自动组装机，选用汽缸作为动力系统，把PLC 应用于控制系统中。通过对灭弧室的形状要求，尺寸要求，强度要求，生产的经济效益等各方面进行详细分析。通过对零件的分析，此零件外形轮廓小，重量轻，尺寸要求精确，组装后强度要求高，生产批量不大。因此在保证质量、安全和提高生产率的前提下，尽量简化结构，做到经济合理。 关键词：机电一体化; 气缸; PLC Abstract The design of the arc chute assembly machine to be a semi-automatic assembly machine with mechanical and electrical integration , use cylinder as the power system, the PLC used to control the system. According to the detailed analysis of the arc chute, such as shape, dimensional, strength and productivity effect and so on. Through the analysis of parts, this part have a small contour, light weight, dimensional requirements accurately, assembled with high strength, not mass production. Therefore, to ensure quality, safety and productivity, the structure to be as simple as possible and economically reasonable. Keywords : cylinder； PLC；mechanical and electrical integration 目 录 第一章 前言............................................................................................1 1.1 本文的选题背景及意义...................................................................1 1.1.2 研究意义......................................................................................2 1.1.3 研究目的......................................................................................2 1.1.4 文献综述......................................................................................3 1.2 本文的研究内容...............................................................................4 1.2.1 研究内容......................................................................................4 第二章 PLC的理论知识.........................................................................5 2.1 PLC的基本组成...............................................................................5 2.1.1 中央处理器..................................................................................6 2.1.2 存储器..........................................................................................6 2.1.3 接口............................................................