不热原因分析（Non thermal analysis）.docVIP

不热原因分析（Non thermal analysis） Analysis of the causes of radiator heat A source: (28 factors) 1.1, moisturizing factor: 1.1.1, constant pressure point: low pressure point low water pump system in tall buildings, not hot. 1.1.2, a water pump, a water pump fault problem, no standby pump system serious water deficit. 1.1.3, inverter failure: water pump inverter fault, not timely replenishment. 1.1.4, expansion water tank: because the signal failure caused by the expansion tank of water water deficit. 1.1.5, a small water box system: severe water deficit, fill the water tank volume can not meet the water needs. 1.1.6, water: an accident caused by some other city water, may also occur, resulting in no water. 1.2, circulation factors: 1.2.1, circulating pump fault: circulating pump, no standby pump system cycle. 1.2.2, intermittent cycle: in order to save electricity, heating management unit often stop the pump system unstable operating condition. 1.2.3, the circulating pump flow: a large area of heat caused by the user. 1.2.4, head of circulation pump: low by the end user is not hot. 1.3, boiler factors: 1.3.1, a small boiler capacity: existing boiler heating capacity can not meet the actual needs of users. 1.3.2, the low efficiency of boiler: boiler capacity seems to meet the needs, but because of inadequate fuel combustion and exhaust temperature of the boiler, boiler water, boiler fouling serious surface heat dissipation caused by boiler efficiency is low, resulting in the stage of heating is not cold. 1.3.3, stop boiler: Boiler failure, no standby furnace is maintenance. 1.3.4, fuel failed: the use of low-grade fuel, low calorific value of fuel, or even to open furnace or often flameout. 1.3.5, fuel consumption: part heating management unit of their own economic interests at the expense of the interests of users using the amount of fuel heat, does not meet the minimum requirements of users, the heating level of non-compliance. 1.4, the heat transfer factor: 1.4.1, the