变矩器维护保养（Torque converter maintenance）.docVIP

变矩器维护保养（Torque converter maintenance） The most common fault of hydraulic torque converter, a power shortage is two, the temperature is too high. The characteristic curve of torque converter shows that when the output torque of the torque converter turbine torque that varies with the change of external resistance, the external resistance increases, the output torque of the torque converter is increased, reducing the rotational speed of the turbine. When the output torque is increased to a certain value, the turbine speed is reduced to zero, while the input torque of the torque converter remains unchanged, that is to say the engine load did not change. Therefore, when the external resistance to a certain value, the output torque of the torque converter (turbine torque) reaches the maximum, and the turbine speed is zero, the machine speed is zero, while the engine is neither smoke nor slow down, dont stall, still lost to the pump wheel torque torque is this kind of phenomenon is called stall. In the stall state, torque converter transmission efficiency is zero, the kinetic energy of the engine supply converter into churning loss, that is heat, so that the torque converter oil temperature rise. Therefore, the use must avoid this situation. In the turbine speed range of the converter maximum transmission efficiency point only one hydraulic transmission achieve stepless speed change, but not absolute, and must be used in turbine speed within a certain range of otherwise, the transmission efficiency is very low. Therefore in driving a hydraulic machine, according to different load changing gear, the best will be placed near the engine throttle rated speed. Long term work in low efficiency area, not only cause the oil, waste of time, and will cause the temperature. Therefore, the normal operation is the throttle, frequently shift, always pay attention to working and hydraulic torque converter. In peacetime repair the installation accuracy will affect the transmission effici