变形缝做法（Deformation joint method）.docVIP

变形缝做法（Deformation joint method） The method of deformation joint begins with the top of the foundation The method of deformation joint begins with the top of the foundation L various structure stitch settings (1) the maximum distance between expansion joints of masonry buildings (m); Masonry classification Roof or floor type Spacing (m) Various masonry Integral or assembled reinforced concrete structure A roof or floor with insulation or insulation Fifty A roof without insulation or insulation Forty Assembly type purlin system of reinforced concrete structure A roof or floor with insulation or insulation Sixty A roof without insulation or insulation Fifty Assembly type purlin system of reinforced concrete structure A roof with an insulating layer or insulating layer Seventy-five A roof without insulation or insulation Sixty Clay brick, hollow brick masonry Clay tile or asbestos cement tile cover Wooden roof or floor A masonry roof or floor One hundred Stone masonry Eighty Silicate block and concrete block masonry Seventy-five Note: 1., when there are practical experience and reliable basis, may not comply with the provisions of this table. Deformation joint method. 2. storey higher than 5m masonry structure single storey house, its expansion joint spacing can be multiplied by 1.3 in the table after the adoption But when the walls are made of silicate blocks and concrete blocks, the masonry shall not be larger than 75m. For the deformation joints of Cheng cheng. 3., the larger the temperature difference, and frequent changes in areas and cold areas not heating houses and structures, the largest expansion joints wall Atlas of deformation and spacing. Should be in accordance with the value of the table to be appropriate to reduce the adoption. 4., the expansion joint of the wall should coincide with the deformation joints of other structures, and the joints should be embedded with soft plastic material When the facade is handled, Shaanxi deformation joint. The gap must